Liquid flow meters, including ceramic detectors, thermal conductivity testers, dilatometers, material testing instruments, elastic modulus meters, etc., are instruments used to detect, measure, observe, and calculate various physical quantities, material compositions, physical properties, etc. Or equipment. Forged Block,Forged Steel Block,Stainless Steel Block,Metal Forged Block Suzhou SNK Machinery Equipment Co.,LTD , https://www.snkforging.com
The flow meter maintenance steps are:
First, the liquid flow meter external wipe steps:
1. Wipe the liquid flow meter with a dry fine cloth or wiping paper first to wipe off the dust or oil, etc. Be careful not to injure the appearance of the instrument.
2. Use clean, dry cotton cloth with industrial alcohol to wipe the appearance of the instrument, especially metal and non-metal surfaces.
Second, the liquid flowmeter mirror wipe steps:
1. Gently wipe the mirror surface with lens paper. Do not use force to avoid damaging the mirror surface.
2. Use a cotton swab dipped in industrial alcohol to gently wipe the surface of the mirror, and wait for the alcohol to evaporate before installing it.
3. The mirror wipe can be divided into a calibration glass lens and a lens lens group. Since the dust particles will cause the black spots of the image, it is important that the mirror surface is wiped. After the device is cleaned, the wipe result must be observed again.
Third, the liquid flow meter granite surface cleaning steps:
1. Wipe the surface of the granite with a dry fine cloth or a wiping paper to wipe off the dirt or grease left by the machine after the measurement.
2. Clean the outer surface of the granite with a clean, dry cotton cloth and wipe it with industrial alcohol. The volatilization of the alcohol will naturally evaporate.
3. If necessary, use granite special maintenance oil and then wipe.
Fourth, the liquid flow meter transmission part: the dry friction part and the lubrication part, dry friction part of the air bearing and the toothless screw transmission mechanism of the distinction.
Dry friction part of the maintenance steps:
1. Wipe the surface with a dry cloth or wiping paper to wipe off dust or oil.
2. Blowers can also be used to blow off dust.
3. When necessary, use a clean, dry cotton cloth with industrial alcohol or high-grade lubricant to wipe the surface.
Liquid Meter Lubrication Section Maintenance Steps:
1. First wipe the dust with a fine cotton cloth.
2. Lubricate part of the liquid flow meter and add lube oil or add it by grease gun.