After many companies purchase the fingerprint access control machine, they are not familiar with the operation and use of the fingerprint access control system and the attendance system. In order to allow operators and users to have a deeper understanding of the fingerprint access control system and the attendance system, the following is a brief introduction to the fingerprint access control system. Machine operation steps for your reference. Fingerprint Access Control Operation Procedure Introduction For new purchasers, follow this procedure to operate the machine. Fingerprint collection Users of new purchases need to learn how to collect fingerprints, and fingerprints can be used normally after the completion of fingerprint collection. 1. Power on the attendance machine, turn on the machine, and make the machine work normally. 2. Press the main menu [MENU] - [User Management] - [User Registration] - [Fingerprint Registration] on the attendance control panel. The screen prompts 'New Registration'? ', press [OK] key, this time to enter the employee's job number, enter and press [OK] to confirm, this screen prompts: 'Please put your finger'. 3. Be careful when putting your finger down. The body of the person being gathered is standing upright relative to attendance. Place the 2/3 position of the fingertip from the tip of the finger and place it on the glass plate of the collector. If you do not slide your finger, press it gently, and you will hear a 'click' and then remove your finger. Also perform the 2nd 3rd press. , Press 3 times to collect a complete fingerprint. After 4.3 presses are completed, press [OK] to save. The screen prompts: 'New registration? 'We can press [ESC] to back up and register. Each employee can collect at least 2 fingerprints for use when one of them has worn and broken. 5. After the backup is completed, press [OK] to save. At this time, the screen prompts: 'continue to back up? 'If you want to continue backup, press [OK]. To end the backup, press [ESC] and proceed with fingerprint registration for the next employee. 6. After the fingerprint registration is completed, the registered finger can be used for fingerprint attendance. According to the method of pressing when collecting fingerprints, it can be done. After pressing, the screen displays the employee's job number and is accompanied by a machine voice prompt 'Thank you'. If the press is unsuccessful, there is a voice prompt 'Please press your finger', then press your finger again or replace it with another finger. 7. In the above step 6, we only saw the employee's job number, did not see the name, in fact, can display the employee's name. Please follow the steps below. 8. Install attendance management system on the computer. Insert the installation CD and follow the on-screen instructions to install it. Note that the program installation path must be changed to the D drive. 9. Connect the attendance machine with the computer. The attendance machine and the computer's communication method include RS232, RS485, TCP/IP, and USB data lines. 10. Open the attendance management system, select the device name and the corresponding connection, you can connect successfully. Rubber Hose Fitting,Rubber Hose Connector,Rubber Hose Coupler,Rubber Hose Adapter Hebei no one but god energy equipment co.,ltd , https://www.hbwsrubber.com
