In the process of driving the bulk feed carrier, speed may be limited, resulting in less torque of the engine. No matter how you step on the accelerator, the speed will not be raised. The following Xiao Bian will analyze the causes of the above imagination. First, the oil pump is blocked and there is insufficient oil supply. Because the quality of the added diesel oil is not good, it is very easy to cause the pump oil port of the oil pump to be blocked by a large amount of impurities. During normal operation, it is difficult for the oil pump to ensure the normal oil supply of the engine, resulting in only a small amount of diesel oil flowing in the entire oil circuit. In this case, the amount of diesel flow is only enough to start the engine. Second, only genuine filter can protect the safety of the oil road. Many bulk feed truck drivers think that the filter is almost on the line and does not need to be particularly good. But to know that one problem with the filter cartridge, the seriousness of the problem, not only is it easy to damage the oil system, but can even damage the engine. Third, the lack of oil pressure, engine speed is limited. Its performance is that after running, dry up the throttle and rotate up to 1800 rpm. Upon inspection, it was found that the rubber gasket on the top of the oil-water separator had aged, and the filter element was almost completely blocked. Moreover, poor quality oil-water separators cannot effectively separate diesel and water. The better the filter is, the better the quality is. The better the protection of piston rings, oil pump nozzles and other components from clogging and wear. In the process of machining titanium alloy, the titanium alloy material itself has low modulus of elasticity, large elastic deformation, high cutting temperature, low thermal conductivity and high chemical activity at high temperature, which makes the sticky knife phenomenon serious, easily aggravating the tool wear and even breakage, which leads to the poor machinability of the titanium alloy. Therefore, machining titanium alloy requires proper cutting tools and good machining technology. Machining Titanium,Titanium Machining Parts,Titanium Cnc Turning Machining Parts Hong Kong RYH CO., LTD , https://www.szcncmachiningparts.com