How is the plastic locker installed?

Take a two-layer plastic locker as an example, you need tools: rubber hammer

The first step: the base to give up side by side, insert single and double side plates, the board has marked down, forward, the direction must not be wrong, with a rubber hammer hit back in place.

Part 2: Insert the alignment plate into the backplane.

The third part: install the connector, first snap the connector onto the side board, pay attention to the up and down direction, and knock the connector forward.

Part 4: Refer to step 1 to install the single and double side plates and then install the top plate. The top plate is knocked into place by the back.

Step 5: Install door panels, multi-function boxes, top seals and other accessories. This step is very simple. After installation, the effect is as shown below.

In some plants, the capacity of Slurry Pump is calculated based on the maximum demand of the process; which occurs only part of time. The excess capacity is usually controlled through a control valve; as a result, a lot of energy is wasted. In order to better meet the requirements of process capability or pressure, the flow control methods of throttling, by-pass control, speed control, impeller trimming and Variable Speed Drives (VFDs) are developed. Variable Frequency Drives (VFDs) are by far the most popular and effective type of adjusting the pump speed. Practice tells us that it is possible for VFDs to save 20-30% of the energy efficiency of the pumping system.

Product features:

1. Saving energy

The VFD controls the motor and automatically adjusts the motor load to make the motor run in an economical running state to achieve the effect of power saving.

2. Lower operating cost

The VFD can greatly reduce the energy cost of the motor, reduce the impact on the equipment after the frequency conversion start, and reduce the maintenance and repairing capacity, so the operation cost will be greatly reduced.

3. Improve pressure control accuracy

The VFD has accurate pressure control ability, which effectively improves the quality of system working condition.

4. Extend the service life of the motor

From the 0Hz starting motor, the starting acceleration time of the VFD can be adjusted to reduce the impact on the electrical and mechanical components of the motor when starting, so as to enhance the reliability of the system and prolong the service life of the motor. In addition, the VFD can effectively reduce the peak value of starting current to a minimum, and can reduce the impact on the grid and other electrical equipment.

5. Reduce the noise of the motor

According to the working condition of the motor, the motor running speed is slowed down obviously after the VFD is installed, so the noise of the motor running is effectively reduced.

Variable Frequency Drive For Pump

Variable Frequency Drive For Pump,Variable AC Frequency Drive For Pump,Variable Frequency Drive For Water Pump,Variable Frequency Drive Solar Pump,AC Variable Frequency Drive For Pump,Variable Frequency Drive For Centrifugal Pump

Shijiazhuang Soarho Machinary Co.,Ltd , https://www.xhslurrypump.com